Ducatisti Forum - View Single Post

**Wazza** · 18 Apr 08, 03:04 PM

I am installing another swingarm on my 2003 ST2. My old one had slight damage from an incorrectly installed muffler scraping on it before I owned it. I bought a second hand swing arm off an ST4 on ebay, I hope they are compatible however there is different numbers stamped underneath and the chain slack sticker is slightly different, one says 30mm slack and the other 32mm! The brake calliper locating pin seems to be in a slightly different position although I am not sure about this and I will measure it in the morning.

Can anyone advise me if they did have the same swingarms.

Also could any one advise on the correct shim clearance for the for the swing arm on the ST2? I assume it is supposed to be very close.

Thanks, Waz from Oz

18 Apr 08, 03:04 PM	#1 (permalink)
Wazza Newbie Join Date: Apr 2008 Location: Sydney's rural outskirts Posts: 19 Wazza's Gallery Bike: 2003 ST2	Advice needed ST4 swing arm on ST2 I am installing another swingarm on my 2003 ST2. My old one had slight damage from an incorrectly installed muffler scraping on it before I owned it. I bought a second hand swing arm off an ST4 on ebay, I hope they are compatible however there is different numbers stamped underneath and the chain slack sticker is slightly different, one says 30mm slack and the other 32mm! The brake calliper locating pin seems to be in a slightly different position although I am not sure about this and I will measure it in the morning. Can anyone advise me if they did have the same swingarms. Also could any one advise on the correct shim clearance for the for the swing arm on the ST2? I assume it is supposed to be very close. Thanks, Waz from Oz