749 airbox removal help

[mono749]

can anyone give me some ideas on how to undo the two screws that hold the ignition/immobilser block! cause the airbox wont lift out


it doesn't mention anything in the manual!

[barry749]

with the black cover off you will be left with 2 10mm studs screw on 2 nuts tighten them against each other then screw out the studs.it is a while since i done mine but i know i done it along these lines hope this helps.

[mono749]

Originally Posted by barry749

with the black cover off you will be left with 2 10mm studs screw on 2 nuts tighten them against each other then screw out the studs.it is a while since i done mine but i know i done it along these lines hope this helps.

thanks for the response barry,i've been out and tried this with no joy its as if they are welded in

[mono749]

any thoughts guys

[Triple9]

Originally Posted by mono749

i've been out and tried this with no joy its as if they are welded in

Have another go,....but this time apply some heat.(hot air gun or good hair dryer)

[MarkST]

Originally Posted by mono749

it doesn't mention anything in the manual!

Which manual ? will this freely downloadable 999 workshop manual help ?

The Spares Network - Downloads - info@thesparesnetwork.co.uk

[mono749]

Originally Posted by MarkST

Which manual ? will this freely downloadable 999 workshop manual help ?

The Spares Network - Downloads - info@thesparesnetwork.co.uk

no mark thats the owners manual and not very indepth,i was on about the one that gets issued to the workshops.

[MarkST]

Originally Posted by mono749

no mark thats the owners manual and not very indepth,i was on about the one that gets issued to the workshops.

Soz, I didn't realise, it's supposed to be the workshop manual. How about this one ? - The Spares Network - Downloads - info@thesparesnetwork.co.uk